maintenance
Perform the engine maintenance indicated below:
Daily
1.Thoroughly remove dirt and oil from the engine and control area. Clean or replace the air cleaner elements as necessary. Check and retighten all fasteners as necessary.
Weekly
1.Remove the fuel filter cap and clean the inside of the fuel tank.
2.Remove or clean the filter at the bottom of the tank.
3.Remove and clean the spark plug (Figure 26), then adjust the spark gap to 0.028~0.031 inch (0.6~0.7 mm). This unit has electronic ignition, which requires no adjustments.
Figure 26. Spark Plug Gap
ENGINE OIL
1.Drain the engine oil when the oil is warm as shown in Figure 27.
Figure 27. Engine Oil (Draining)
2.Remove the oil drain bolt and sealing washer and allow the oil to drain into a suitable container.
3.Install drain bolt with sealing washer and tighten securely.
4.Replace engine oil with recommended type oil as listed in Table 4. Engine oil capacity is 1.16 quarts (1.1 liters). DO NOT over fill.
DANGER
DO NOT use gasoline as a cleaning solvent, because that would create a risk of fire or explosion.
ENGINE AIR CLEANER
1.Remove the air cleaner cover and foam filter element as shown in Figure 28.
2.Tap the paper filter element (Figure 28) several times on a hard surface to remove dirt, or blow compressed air [not exceeding 30 psi (207 kPa, 2.1 kgf/cm2)] through the filter element from the air cleaner case side. NEVER brush off dirt. Brushing will force dirt into the fibers. Replace the paper filter element if it is excessively dirty.
3.Clean foam element in warm, soapy water or
Figure 28. Engine Air Cleaner
page 24 — Pro12 hydraulic mixer • operation manual — rev. #0 (05/06/13)
