![](/images/new-backgrounds/1010552/1055219x1.webp)
components
1
2
3 7 4
6
3 3
5
Figure 1. Submersible Pump Components
Figures 1 shows the location of the basic components for the SS233 submersible pump. Listed below is a brief explanation of each component.
1.AC Power Cable — This unit is supplied with a 20 ft. (6.1 meters) AC power cable. Always check the cable for signs of wear. NEVER! use a defective power cable. Replace the cable immediately if the cable is worn or defective.
2.
3.Discharge Port — Connect a 2" NPT hose to this port. Remember to adequately support the discharge hose to avoid stress on the pump.
4.Thermal Overload Protection — This pump has an internal thermal overload protection device that will
5.Strainer Base — This strainer base is made of durable plastic. DO NOT pump large objects or debris with this pump. This pump is for pumping water only. For
6.Electric Motor — This unit utilizes a
7.Volute/Impeller — Impellers are constructed of thermo plastic to minimizes wear and prolong service life.
page 10 — SS233 Submersible Pump • operation and parts manual — rev. #2 (03/22/10)