saw components
Figure 2 shows the location of the basic components of the TP7X saw. Listed below is a brief explanation of each component.
1.AC Power Cord — Plug this cord into a 125VAC receptacle when starting of the electric motor is required.
2.
3.Rubber Splash Guard — Keeps water from splashing from the blade.
4.Electric Motor — This unit uses a 115V, 60 Hz, 1 HP electric motor.
5.Overcurrent Breaker Button — When a thermal overload condition exists, press this button to reset the breaker. Allow time for the electric motor to cool down before reseting the breaker.
6.Cutting Blade — This unit uses a
7.Power ON/OFF Switch — To turn on the saw place in the ON position. Place in the OFF position to shut down the saw.
8.Water Pump Power Receptacle — Plug the water pump power cord into this AC receptacle.
9.Blade Guard — Protects the user from the cutting blade. NEVER operate the saw with the blade guard removed.
10.Blade Guard Adjustment Knob — Turn knob clockwise to loosen and remove blade guard. Turn counterclockwise to tighten.
11.Blade Guard Brushes — Prevents foreign matter and debrisfromaccumulatingonthesawblade.Replacebrushes immediately when they become worn or damaged.
12.CuttingTable — Place material to be cut on this rubber padded table. For ease of cutting, this table has been placed on rails so that it can easily slide back and forth.
13.Ruler Backstop — When cutting, place material against backstop. Use measurement rail (ruler) to determine where material is to be cut.
14.Stopper — Place stopper in water tray when filling with water.
15.Cutting Head Adjustment Knob — Turn knob clockwise to loosen and position cutting head to desired height. Turn counterclockwise to tighten.
16.Water Tray — When wet cutting is required, fill with clean fresh water. Make sure submersible pump is totally immersed in water.
17.Electric Water Pump — The electric water pump for this saw requires 115 VAC. Plug power cord of electric water pump into AC receptacle located on conduit box. NEVER run pump dry. Pump must be immersed in water.
18.Water Lines — Replace the clear vinyl tubing water lines when they become brittle, worn or clogged.Water kits are available through your Multiquip dealer.
19.MaintenanceWrench — Use this
20.MasterGuide Template Base — Mounts to ruler backstop to ensures precision while making cuts.
21.Bearing Housing — Houses permanently lubricated ball bearings to allow motor shaft to rotate smoothly.
22.Metal Frame Handles — There are two carrying handles on each side of the saw. Grip these handles when transporting of the the saw is required.
TP7X TILE SAW • operation manual — rev. #0 (03/04/11) — page 15
