Multiquip TP7X operation manual Shut down Procedure, Wait for the cutting blade to stop rotating

operation

3.Push the cutting table with the material, slowly and evenly until the cut is complete. Move the cutting table back and remove the cut pieces.

4.Avoid overloading the motor when cutting. However, the electric motor is protected with a manual-reset thermal overload switch that will turn the saw off if the motor is overheated. In the event that the switch is tripped, turn the “ON/OFF” switch to the “OFF” position and allow the motor to cool before attempting to restart.

Shut down Procedure

1.Place the power ON/OFF switch (Figure 16) in the OFF position (down).

Figure 16. Power ON/OFF Switch (OFF)

2.Wait for the cutting blade to stop rotating.

3.Disconnect the saw's AC power cord from the power source. NEVER leave the saw connected to a power source when unattended. This will prevent accidental starting.

4.Using a soft cloth, clean any excess debris or residue that may have accumulated on the saw.

5.Store saw in a clean dry location where it will be out of the reach of children.

TP7X TILE SAW • operation manual — rev. #0 (03/04/11) — page 23