MAINTENANCE
INSTALLATION
1.Slide the motion drive belt between the stack pulley and the belt guides (Figure 29). Install the motion drive belt on the top pulley of the stack pulley. Make sure the “V” side of the belt is against the pulley.
2.Push the motion drive belt through the opening between the steering plate and the engine plate.
3.Install the end of the motion drive belt around the drive pulley (Figure 26).
4.Tighten the belt guides at the drive pulley (Figure 27).
5.Put the belt around the idler pulley (Figure 26, Figure 31). Assemble the idler pulley. Fasten the idler pulley with the hex nut. Make sure the flat side of the belt is against the idler pulley. Also, make sure the belt is not twisted.
6.Make sure the motion drive belt is inside all the belt guides (Figure 26, Figure 27).
7.Attach the adjuster nut and shift link to the adjuster bracket with a hair pin (Figure 28). See “How To Adjust The Shift Lever”.
8.Attach the steering shaft assembly to the steering plate with two screws (Figure 30).
9.Attach the access panel (Figure 30).
10.Check the routing of the motion drive belt. Make sure the motion drive belt is installed correctly on the idler pulley. Make sure the steering shaft assembly in inside the motion drive belt (Figure 31).
11.Install the battery.
12.Before you use the unit, check the adjustment of the clutch. See the instructions “How To Check And Adjust The Clutch”.
13.Install the mower housing. See the instructions “How To Install The Mower Housing”.
Stack Pulley 
Steering Shaft
Assembly 
Motion Drive |
Belt |
Idler
Pulley
Figure 31
29 |
