All input, output and power connections should be made with the mains power switched OFF.
INPUT CONNECTIONS
The kW 500 Integrated amplifier has a pair of phono inputs for moving magnet (MM) pickups.
Some turntable/pickup arm combinations are fitted with an extra wire for chassis earthing. This should be connected to the earth terminal on the back panel.
The kW 500 also has five “line level” inputs which are electrically identical, and therefore suitable for use with any source component having an output of at least 300mV. The sockets on the rear panel are marked CD, SACD, TUNER, AUXiliary, and TAPE, to correspond with function buttons on the front panel.
Using good quality
Connect the kW 500’s TAPE input sockets to the line output of your tape recorder, and kW 500’s TAPE RECORD output sockets to the line input sockets of the tape deck.
OUTPUT CONNECTIONS
Connect your loudspeakers to the terminals on the back panel marked as LEFT and RIGHT SPEAKER outputs.
CONNECTIONS
PRE-AMPLIFIER OUTPUT
The kW 500 Integrated amplifier has its
This is to allow
In this arrangement, typically the kW 500’s speaker outputs are used to drive the speak- er’s “tweeter” (high audio frequencies), and an external stereo amplifier drives the “woofer” (low frequencies).
The kW 500’s PRE OUT RCA sockets would therefore be connected to the input of the external “woofer” amplifier in this example.
If you are in doubt about
BEFORE SWITCHING ON
Connect the two accessory power supply leads into the RIGHT and LEFT PSU (Power Supply Unit) INPUT sockets at the rear of the amplifier. The other ends of the leads plug into corresponding marked sock- ets on the back panel of the power supply unit.
A single lead with smaller plugs connects between the
Plug the accessory IEC mains lead into the rear PSU mains socket, then the other end into a wall outlet. Turn the volume control on the front panel to low (anticlockwise).
Issue 2: Sept 2004 | kW 500 Integrated Amplifier | Instructions for use Page 7 of 10 |
|
|
|