STARTING . . . .
Press the POWER button on the front panel of the kW 500 power supply unit. The blue LED above the button should now light.
The LEDs in the feet of the amplifier unit will light red for about fifteen seconds indi- cating that all audio outputs from the unit are muted. Feet illumination then fades over approximately fifteen seconds to amber, indicating that output is no longer muted, and that your kW 500 amplifier is now ready for use. However, after a further period of about 35 minutes, the colour fades to blue, confirming that the amplifier has fully warmed up.
Unless using your amplifier for
Select the required audio input source by pressing an appropriate function button on the front panel, or remote control. Now adjust the volume control to obtain the pre- ferred sound level.
OVERLOAD PROTECTION
If for any reason, speaker output power of your kW 500 is excessive, for example at very high volume setting or due to wrong load impedance, an overload protection cir- cuit is activated. The motorised volume control will be turned down automatically, and the four illuminated feet will change colour to violet for about five seconds, or until the problem is removed.
OPERATION
TAPE RECORDING
To record, simply select the required source with the input selector button on the front panel or remote control. This source will now be routed to the kW 500’s TAPE RECORD output for recording by the external tape deck. You will also be able to hear the selected source through the loud- speakers.
Note - adjustment of the volume control has no effect on the recording level.
OFF TAPE MONITORING
The kW 500 Integrated amplifier has a sin- gle tape circuit with facility for
In conjunction with a
The TAPE MONITOR button on the front panel can now be used to switch between the original source sound and the recorded version, allowing direct comparison.
On some
If in doubt, please refer to your tape deck operating manual.
Issue 2: Sept 2004 | kW 500 Integrated Amplifier | Instructions for use Page 8 of 10 |
|
|
|