NAD C340 owner manual Tone Defeat

7. TONE DEFEAT

The TONE DEFEAT switch by-passes the tone control section of the NAD C340. If the Tone Controls are not normally used and left in the 12 o’clock position, then it is advisable to switch out the Tone Control section altogether by using this switch. In the ‘out’ position, the Tone Control circuits are active, pushing the TONE DEFEAT switch ‘in’ bypasses the Tone Control section.

8. BALANCE

The BALANCE control adjusts the relative levels of the left and right speakers. The 12 o’clock position provides equal level to the left and right channels. A detent indicates this position.

Rotating the control clockwise moves the balance towards the right. Rotating the control anti-clockwise moves the balance to the left. The BALANCE control does not affect recordings made using the Tape outputs but will affect the signal going to the Pre-amp output (Pre Out).

9. VOLUME

The VOLUME control adjusts the overall loudness of the signals being fed to the loudspeakers. It is motor driven and can be adjusted from the remote control handset. The VOLUME control does not affect recordings made using the Tape outputs but will affect the signal going to the Pre-amp output (Pre Out).

On the remote control handset, press the MUTE Button to temporarily switch off the sound to the speakers and headphones. Mute mode is indicated by the active input LED flashing. Press MUTE again to restore sound. Mute does not affect recordings made using the Tape outputs but will affect the signal going to the Pre-amp output (Pre Out).

TO MAKE A RECORDING

When any source is selected, its signal is also fed directly to any tape machine connected to the TAPE 1 or TAPE 2 OUTPUTS for recording.

TAPE TO TAPE COPYING

You can copy between two tape machines connected to your NAD C340. Put the source tape in the recorder connected to Tape 1 and GB the blank tape into the recorder connected to Tape 2. By selecting TAPE 1 Input you can now record from Tape 1 to Tape 2 and

monitor the signal coming from the original tape.

REMOTE CONTROL HANDSET

The Remote Control handset handles all the key functions of the NAD C340 and has additional controls to remotely operate NAD Tuners, Cassette and CD machines. It will operate up to a distance of 16ft (5m).

Alkaline batteries are recommended for maximum operating life. Two AAA (R 03) batteries should be fitted in the battery compartment at the rear of the Remote Control handset. When replacing batteries, check that they have been put in the right way round, as indicated on the base of the battery compartment.

Please refer to previous sections of the manual for a full description of individual functions.

NOTE: The remote control handset supplied with the C340 is of a universal NAD type, designed to operate several NAD models. Some buttons on this handset are inoperative as the functions aren’t supported by the C340.

The Stand-by (large green button) function, Video 2 and Video 3 input selector, and Speakers A and Speakers B buttons on the remote control handset are inoperative in the case of the C340.

The input selector buttons perform the same functions as the buttons labelled the same on the front panel. There are a few differences and extra functions with the remote control handset however:

TUNER AM, TUNER FM

Selects the Tuner input on the NAD C340 and respectively the AM or FM waveband on a separate remote controllable NAD Tuner.

MUTE

Press the MUTE Button to temporarily switch off the sound to the speakers and headphones. Mute mode is indicated by the active input LED flashing. Press MUTE again to restore sound. Mute does not affect recordings made using the Tape outputs but will affect the signal going to the Pre-amp output (Pre Out).

MASTER VOLUME

or respectively increases or decreases the Volume setting. The motorised Volume Control on the front panel will indicate the level set.

Other than the commands relating to the NAD C340 amplifier itself, there are other buttons which will operate most NAD CD players and Cassette decks equipped with NAD Link:

TUNER CONTROL (for use with NAD Tuner)

BANK Selects a bank of preset stations.

PRESET or selects respectively higher or lower number station preset.

CD PLAYER CONTROL (for use with NAD CD Player)

engages Pause

engages Stop

engages Play or toggles between Play and Pause

or engages Track skip; Press once to respectively go to

the next track or to return to start of current or previous track. NEXT DISC Go to next disc (for NAD CD changers).

CASSETTE DECK CONTROL

(For use with single (DECK B) or double transport (A and B) NAD Cassette Decks)

or engages Forward Play or Reverse Play.

Record / Pause. Press to put cassette deck into record- pause. Press Play to start recording.

Stops Play or Recording.

engages Rewind. engages Fast Forward.

NOTE: Direct sunlight or very bright ambient lighting may affect the operating range and angle for the remote control handset.

6