NAD L 53 owner manual Delete Mode, Loading CODE-LIBRARIES

Operation

USING THE HTR L53 REMOTE CONTROL

DELETE MODE

The HTR L53 can store learned, copied, and “default library” commands on any single button. (The default library commands are the pre-programmed NAD codes, such as the native L53 commands on the “AMP” “page.”) You can delete commands by layers back “down” to the default library command on any button, removing learned commands, punched-through functions, and copied buttons.

NOTE

•The default library commands cannot be deleted, so you need not worry that using Delete Mode might cause irreparable changes.

To enter Delete Mode, simultaneously press-and-hold for 3 seconds both the desired button’s Device Selector button and the “RTN” button, until the Learn LED turns green. Press the function button whose command you wish to delete; the Learn LED flashes; the number of times indicates which type of function has become active-see the table below. Press the active Device Selector button again to exit Delete Mode.

NOTE

•You may delete multiple function-button commands on the same Device Selector “page,” but to delete from more than one Device Selector page you must exit Delete Mode and then re-enter it on the required page.

Flashes Command Type

1Default Library Command

2Copied Library Command

3Learned Command

LOADING CODE-LIBRARIES

The HTR L53 can store a different library of default NAD codes for each of its Device Selector “pages.” If the original default library does not control your NAD CD player, tape deck, DVD player, or other component, follow the procedure below to change the code-library.

Begin by ensuring that the component you wish the HTR L53 to control is plugged in and powered-up (“on,” not merely in standby). To enter the HTR L53’s Library Mode, simultaneously press-and-hold for 3 seconds both the desired Device Selector button and the “PROGRAM” button, until the Learn LED turns green. While keeping the HTR L53 pointed toward the component, enter the first appropriate three-digit code-library number from the table below. If the component turns off, press “ENTER” to accept that code-library number and exit the Library Mode. If the component does not turn off, enter the next three- digit code-library number from the table. When you enter the correct number the component will turn off; press “ENTER” to accept that code-library number and exit the Library Mode.

NAD-brand component	HTR L53 code-library numbers
CD Player (new)	200
CD Player (old)	201
DVD T562	600
DVD T550, L55	601
DVD T531, T571	602
DVD T512, T532, T572	602
L56	604
DVD T513, T533	605

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

27