NAD L 76 owner manual Connecting Speaker Systems, Assembling The Am Loop Antenna, How To Connect

CONNECTING ANTENNAS

ASSEMBLING THE AM LOOP ANTENNA

1Rotate the outer frame of the antenna

2Insert the bottom edge of the outer frame into the groove on the stand.

Insert into the groove

3Extend the antenna cord

CONNECTING SPEAKER SYSTEMS

CAUTION

To avoid damage the speakers by inputting a sudden high-level signal, be sure to switch the power off before connecting the speakers.

Connect the cable from each speaker to the corresponding terminal on the rear of the receiver.

•Most speaker cables have different markings, textures or colors to help you tell the difference between negative and positive.

•Be sure to connect the positive (+) terminal on each speaker to the positive (+) terminal on the receiver. Similarly, connect the negative (-) terminal on the speaker to negative (-) terminal on the receiver.

NOTES

• Use speakers with a nominal impedance of 8 ohms or more.

HOW TO CONNECT

1 Strip back the cable covering by about 1 cm and twist the wire strands together.

2 Turn the terminal cap counterclockwise to loosen it. The speaker terminal caps cannot be fully removed from the base.

3 Insert the wire into the terminal fully and turn the terminal cap clockwise to securely connect it.

4Make sure it is fastened firm by pulling the cable lightly.

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

7