NAD T562 Dolby PRO Logic Surround Sound, Deutsch Français English, Italiano Español Nederlands

Models: T562

1 34
Download 34 pages 55.6 Kb
Page 19
Image 19

Setup

CONNECTING TO A SURROUND SOUND SYSTEM

DOLBY PRO LOGIC SURROUND SOUND

One can enjoy the high quality sound of Dolby Pro Logic Surround Sound if your A/V receiver is equipped with a Dolby Pro Logic Surround Sound processor or decoder.

To enjoy Dolby Pro Logic sound from this DVD player you need the following:

DVD recorded in Dolby Pro Logic format.

Dolby Pro Logic A/V receiver equipped with a Dolby Pro Logic decoder, or Dolby Pro Logic decoder and power amplifier

5 speakers

Connection example

From the

MIXED AUDIO L/R jacks

75-Ohm audio cables

To RCA audio input jacks of the surround sound receiver equipped with a Dolby Pro Logic decoder

From S-VIDEO / Component Video / Composite or SCART

S-VIDEO / Component / Composite 75–Ohm coaxial or SCART cable

To S-VIDEO / Component / Composite or SCART inputs of the receiver

DEUTSCH FRANÇAIS ENGLISH

Front Speaker

(left)

Rear speaker (left)

Centre speaker

Front speaker

 

(right)

TV

 

TV

 

 

Rear speaker (right)

ITALIANO ESPAÑOL NEDERLANDS

WITH A RECEIVER EQUIPPED WITH A DOLBY DIGITAL DECODER

Connect the equipment the same way as described in Enjoying Dolby Digital Sound. Refer to that A/V receiver’s owner’s manual and set the receiver so you can enjoy Dolby Pro Logic Surround sound.

WARNING

Do not set the Digital Audio Output of this DVD player to ‘Analogue Off’ unless you are connecting the DIGITAL OUT jack of this DVD player to an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the speakers. (Refer to Initial Setup Settings, Audio)

NOTE

Refer to the owner’s manual of your audio equipment as well. Depending on your Dolby Digital surround sound decoder, the decode rate may be 96 or 48K. When you connect the T562 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections. The output sound of the T562 has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound. Turn off the receiver before you connect or disconnect the T562’s power cord. If you leave the receiver power on, the speakers may be damaged.

SVENSKA PORTUGUÊS

19

Page 19
Image 19
NAD T562 Dolby PRO Logic Surround Sound, Deutsch Français English, Italiano Español Nederlands, Svenska Português