Lenovo 7567, 7558, 5068 manual Diagnostic Error Code FRU/Action

Diagnostic Error Code	FRU/Action
015-196-XXXUSB port test halt, error threshold exceeded	1. Press F3 to review the log file.
	2.	Restart the test to reset the log file.
015-197-XXXUSB port test warning	1. Make sure the component that is called out is
		connected and/or enabled. See Chapter 6 “Using
		the Setup Utility program” on page 53.
	2.	Re-run test.
	3.	Replace the component that is called out in warning
		statement.
	4.	Replace the component under test.
015-198-XXXUSB port test aborted	1. If a component is called out, make sure it is
		connected and/or enabled. See Chapter 6 “Using
		the Setup Utility program” on page 53.
	2.	Flash the system and re-test. See “Flash update
		procedures” on page 151.
	3.	Go to “Undetermined problems” on page 78.
015-199-XXXUSB port test failed, cause unknown	1. Go to “Undetermined problems” on page 78.
	2.	Flash the system and re-test. See “Flash update
		procedures” on page 151.
	3.	Replace component under function test.
018-000-XXXPCI Card Test Passed	No action
018-0XX-XXXPCI Card Failure	1.	Riser card, if installed.
	2.	System board
018-195-XXXPCI Card Test aborted by user	1. PCI card
	2.	Information only Restart the test, if necessary
018-196-XXXPCI Card test halt, error threshold exceeded	1. Press F3 to review the log file
	2.	Restart the test to reset the log file
018-197-XXXPCI Card test warning	1. Make sure the component that is called out is
		connected and/or enabled. See Chapter 6 “Using
		the Setup Utility program” on page 53.
	2.	Re-run test.
	3.	Replace the component that is called out in warning
		statement.
	4.	Replace the component under test.
018-198-XXXPCI Card test aborted	1. If a component is called out, make sure it is
		connected and/or enabled. See Chapter 6 “Using
		the Setup Utility program” on page 53.
	2.	Flash the system and re-test. See “Flash update
		procedures” on page 151.
	3.	Go to “Undetermined problems” on page 78.
018-199-XXXPCI Card test failed, cause unknown	1. Go to “Undetermined problems” on page 78.
	2.	Flash the system and re-test. See “Flash update
		procedures” on page 151.
	3.	Replace component under function test.

66ThinkCentre Edge Hardware Maintenance Manual