Nady Systems MRC-11X owner manual General Specifications, Troubleshooting

Models: MRC-11X

1 13
Download 13 pages 46.66 Kb
Page 10
Image 10

GENERAL SPECIFICATIONS

Operating Frequency Range

462.563MHz-467.713MHz

Number of Channels

22 total/GMRS + FRS

Effective Radiated Power

GMRS channels: 3W @ 6.0VDC

 

FRS channels: 500mW @ 6.0VDC

 

(power automatically selected for

 

channels as required by FCC)

Range

Up to 7 miles (11Km) line-of-sight,

 

3/4 to 2 miles typical

Modulation

FM, +/-1.5kHz

Carrier Frequency stability

+/- 2PPM

Harmonic Suppression

>50dB

Carrier Attack Time

30ms

Receiver I.F. Frequencies

1st: 21.6MHz, 2nd: 455KHz

Receiver Sensitivity (12 dB Sinad)

0.4uV

Receiver Selectivity

50dB

Max S/N ratio @-60dBm RF input

50dB

Squelch sensitivity

-118dBm

Attack time

120ms

Closing time

200ms

Nominal Audio Output

200mW

Audio Frequency Response

300-3000Hz

Audio distortion

<1% (@1KHz deviation and 1mV RF input)

Max. Audio Output @10% THD

350mW

Internal Speaker (deactivated when using headset)

8 ohm/0.25W

Internal Microphone (deactivated when using headset)

Electret condenser

Microphone Sensitivity

10mV @ 1.5KHz deviation

Low Battery Display Threshold

4.3-4.6VDC

Transmit Current (4.6VDC High Power)

<0.8A (TX); <30mA (STBY); <100mA (RX)

Current Drain (Intercom)

<100mA

Standby Current (4.6VDC)

<30mA

Power Required

4 Ni-Cad, NiMH

 

or Alkaline AAA batteries (4.6-6.0 VDC)

Battery Life 4.6VDC (4xAAA)

>48 HR (RX)

Max. Audio output @ 10% THD Current

<200mA

Dimensions/Weight

2.5" X 4.0" X 1.0" (63.4 X 101.6 X 25.4mm)

 

5.1oz / 143g (without batteries)

TROUBLESHOOTING

SYMPTOM — No Power

SOLUTION

Check batteries. Ensure that the batteries are installed correctly

The batteries may be weak.

Replace old batteries with four (4) new AAA alkaline or fully charged Ni- MH or NiCad rechargeable batteries.

SYMPTOM — Weak Reception

SOLUTION

Press the UP button to increase VOLUME.

The receiving signal may be weak and/ or out of range. If this happens press the SCAN button to defeat the AutoSquelch .

SYMPTOM — Can Not Change Channels

SOLUTION

To change channels, press the MOD button until the Channel number flashes on the LCD Screen. Press the UP or DOWN button to change channels.

Batteries may be weak and need replacement. Replace with new batteries if the BATTERY CHARGE LEVEL indicator is low.

SYMPTOM — Limited Range

SOLUTION

Batteries may be weak and need replacement. Replace with new batteries if the BATTERY CHARGE LEVEL indicator is low.

The maximum range will vary depending on terrain and environment. Open fields provide the maximum range, while structures, heavy foliage and use in buildings and in vehicles may limit the range significantly.

Wearing the radio close to the body, such as in a pocket or on a belt, will decrease range. Change the location of the radio away from the body for optimum range under any conditions.

SYMPTOM — Sound Distortion Problems

SOLUTION

If you are transmitting, speak in a normal tone of voice, 1 to 2 inches away from the

MICROPHONE.

If you are receiving, lower the VOLUME to a comfortable level.

Radios may be too close. Radios must be at least 5 feet apart. Increase your separation distance.

Radios too far apart. Obstacles may be interfering with transmission. Shorten your operating distance.

18

19

Page 10
Image 10
Nady Systems MRC-11X owner manual General Specifications, Troubleshooting