Panel Controls and connections
10. FUSE COMPARTMENT
Replace with only the same type fuse. If the fuse blows continuously, have the unit serviced by qualified personnel. The
11. AC VOLTAGE SELECTOR SWITCH
Before plugging in the power cord, check to see that the unit is set for the proper voltage for your area: ~115V (60Hz) or ~230V (50Hz).
12. HEAT SINK
The heat sink can get very hot during high power operation. Make sure to leave properly ventilated and avoid touching.
13. MOUNTING SOCKET |
|
|
|
|
On the bottom panel of the |
|
|
|
|
is a 5/8” dia. socket for mounting the |
|
| 13 |
|
|
|
| ||
on your mic stand, you may require |
|
|
|
|
the optional |
|
|
|
|
Adapter for most secure mounting. For |
|
|
|
|
ordering, see | ||||
Accessories Ordering Form included. | standard mounting socket | Stand Adapter |
SPECIFICATIONS
Mic Input |
| balanced XLR |
Input Impedance | 2KΩ | |
Maximum Input | ||
Sensitivity (for max output | ||
w/Volume max) | ||
Line Input | balanced/unbalanced TRS 1⁄4” | |
Input Impedance | 20KΩ | |
Maximum Input | (10KΩ unbalanced) | |
+22dBm (10V) | ||
Sensitivity (for max output | ||
w/Volume max) | ||
Line Output |
| balanced XLR |
Output Impedance | 1.4KΩ | |
Maximum Output | 15.5dBm (4.3V) | |
(w/10K load) |
| |
EQ and Volume | rotary knobs | |
High |
| |
Mid |
| |
Bass |
| |
Headphone Output | 1⁄4” TRS Stereo | |
Power |
| 2 x 80mW @ 32Ω |
Power Amp Output | 2 internal speakers, | |
Power |
| 2 external 1⁄4” outputs |
| 2 x 50W RMS @ 8Ω | |
|
| (Total 100W RMS) |
|
| 2 x 75W RMS @ 4Ω |
|
| (Total 150W RMS) |
Frequency Response | 20Hz – 50KHz |
THD | 0.055% |
S/N | |
Noise Floor | .200uV |
Amplifier protection | clipping LEDs, |
thermal runaway, short circuit, | |
Internal Speakers | 5” |
Impedance | 8 Ω |
Voice Coil diameter | 1” |
Power Requirements | Selectable, |
115VAC/60Hz or 230VAC/50Hz |
Fuse Requirements | 5x20mm glass tube F.B. |
| 6A 250V @ 115VAC |
| 3A 250V @ 230VAC |
Weight | 9.6 lbs. (4.4 Kg) |
Dimensions (HWD) | 11.1” x 7” x 6.1” |
| (28 x 18 x 15.5 cm) |
Specifications subject to change at any time without prior notice for purposes of product improvement
6