Panel Controls and connections
Note, the
5. EXTERNAL SPEAKERS
The
The
When additional speakers are connected to the two External Speaker outputs, they are automatically wired in parallel with each internal speaker, reducing the total impedance of each channel. If an 8Ω speaker is connected to each output, the power amp can deliver up to 75W RMS to each channel – that means 37.5W per speaker. If the internal speakers are turned off in this configuration, each 8Ω external speaker
can receive up to 50W RMS of power.
6. INTERNAL SPEAKERS ENABLE
When external speakers, or headphones, are being used, it may be desirable to turn off the internal speakers to decrease noise, or, to increase the power somewhat to the external speakers. When the External Speakers
7. HEADPHONES
The Headphone 1⁄4” stereo output can be used to monitor the signal post Volume and EQ. It is capable of powering headphones with impedances of 8Ω or greater. The internal speakers can be used simultaneously or turned off using the Internal Speakers Enable switch.
8. POWER
This switch turns the AC power on and off as indicated by the front baffle green Power Led.
9. POWER CONNECTOR
The IEC jack is used to connect the power cord to the AC Power Source.
[Caution: Never remove the center grounding pin as this can cause a serious safety hazard and will immediately void your warranty.]
12 | 9 | 10 |
11
5