MERLIN 232
MERLIN K 232 headphones with integrated receiver
2 NiMH AAA size rechargeable batteries inside the headphones
Charger (6 VDC, 100 mA)
b)Power to the transmitter is off (the OFF/FREQ selector
(1) is at "OFF") and the charging function is inactive. The transmitter will not switch on even if audio signal is fed to the input.
c)The battery is dead.
Note:
If you switch the transmitter on, the status LED (2) will always be lit green or yellow for several minutes and then extinguish or change to red, depending on the current operating mode.
3INPUT LEVEL: This slide switch lets you match the input gain of the transmitter to the audio output level of the device to which you have connected your transmitter.
Neoprene bag | 4 Level meter LED: This LED will flash green in step with |
| |
| the audio signal to indicate the transmitter input gain opti- |
| mally matches the level of the audio signal fed to the |
Velcro strip | transmitter. |
If the LED flashes green only rarely or does not illuminate | |
| at all the input gain is too low. |
| If the LED is lit red, the input gain is too high and the |
| sound will be distorted. |
Information sheet with access code for
MERLIN Internet Bar
Warranty card
If any of these components is missing, contact your AKG dealer immediately.
2.3 Transmitter (Fig. 1)
1OFF/FREQ: This slide switch provides four positions:
OFF: Power to the transmitter is off.
FREQ 1 - 2- 3: Power to the transmitter is on and the transmitter is tuned to one of three selectable carrier fre- quencies ("1", "2", or "3") within the 864 MHz band.
2Status LED: This tricolor LED indicates the following operating modes of the transmitter:
Green: The transmitter is on and audio signal is present at the input. The charging function is inactive.
Yellow: The transmitter is on and audio signal is present at the input. The battery is being charged.
Red: a) The transmitter is on and no audio signal is pres- ent at the input. The battery is being charged.
b) The transmitter is off and the battery is being charged. Flashing green: The battery will be dead in about 60 min- utes.
Dark: a) The transmitter is on and no audio signal is pres- ent at the input. The charging function is inactive.
5Stereo connector: The integrated mini jack plug allows you to connect the transmitter directly to any audio output on a stereo mini jack (Walkman, MD recorder, MP3 player, stereo system, TV set, computer, etc.)
6Stereo adapter: The supplied mini to 1/4" stereo adapter allows you to connect the transmitter to a 1/4" headphone output jack.
7Charging socket: 0.1 in. coaxial socket for connecting the charging cable of the charger.
8Battery compartment for the supplied 1.2 V NiMH re- chargeable battery.
2.4Headphones (Fig. 2)
9 Folding arches
10On/off switch
11Status LED: This tricolor LED indicates the following operating modes:
Green: Power to the headphones is on, the charging func- tion is inactive.
Yellow: Power to the headphones is on, the batteries are being charged.
Red: Power to the headphones is off, the batteries are being charged.
10
