
Introduction
Congratulations! You have just purchased one of the finest professional effects pedals on the market today. This unit was developed using the expertise of professional sound engineers and working musicians. You will find your new NADY AUDIO
Thanks for selecting NADY AUDIO as your choice for a Tremolo/Vibrato pedal
Features
•Dual, all tube signal path design uses two premium 12AX7A vacuum tubes for the warmest, richest, and most natural sounding tremolo and vibrato sounds available
•Rate/Intensity controls offer the widest range possible of tremolo/vibrato effects
•Choice of three types of note bending vibratos which mimic Leslie, Wurlitzer, Hammond and other classic organ vibratos
•Output control offers considerable boost and a powerful tone
•Compact enough for a paddle board
•Rugged 14 gauge steel housing and
Controls and Connections
(1) | (2) | (3) | (4) |
|
|
| |
(10) |
|
| (9) |
|
|
| (8) |
(7) |
|
|
|
(11) |
|
|
|
(1) OUTPUT
The Output control adjusts to overall signal output output level
(2) RATE
The Rate knob adjusts the speed of modulation for the Vibrato or Tremolo. As the RATE knob is turned from the
(3) RATE INDICATOR
The Rate LED blinks at the same rate as the effect is modulating, as selected by the Rate knob.
(4) INTENSITY
The Intensity Knob adjusts the amount of Vibrato or Tremolo that will effect your signal. As the INTENSITY knob is turned from the counter- clockwise (minimum) position to the clockwise (maximum) position, the amount of the effect will increase.
(5) ON/OFF SWITCH
This switch is between the effected signal (ON) and the uneffected (bypassed) signal (OFF). When in Bypass mode the input is connected directly to the output.
(6) ON/OFF INDICATOR
When the LED lights GREEN, the signal passes through the effects modulation selected (Tremolo or Vibrato ON). When the LED is RED, the single is bypassed (OFF).
(7)VIBRATO/TREMOLO SWITCH
This selects the type of effect desired.
(8)VIBE SWITCH
When the
(9) INPUT
Connects to guitar/keyboard/audio source.
(10)OUTPUT
Connects to amplifier.
(11)POWER ADAPTER JACK
Use only the special Adapter provided.
(6) | (5) |
Tube Replacement
Change the tubes only after noticing a market degradation in audio. The
1.Disconnect all wires, cables into the unit.
2.Remove the top panel knobs carefully, pulling straight off to avoid damage.
3.Remove all nuts and washers for the footswitch, the potentiometers and the IN/OUT jacks.
4.Remove all screws — 8 screws from the
bottom panel, 4 screws from each side panel.
5.Hold the tube socket to loose tube, one at a time. (Tube type:
6.Insert the new tubes by lining up the pins to the socket and firmly push the top of the tube.
7.Reverse process as item