OPERATING INSTRUCTIONS
UHF-16 Receiver
1.Mounting the Receiver a. Table Mounting
To mount a receiver on a table or other horizontal surface, attach the four supplied rubber feet to the bottom corners of the receiver and place the receiver on the mounting surface.
b. Rack Mounting a Single Receiver
If you want to rack mount a single receiver in an audio equipment rack, contact the Nady Systems Service Department (see SERVICE FOR YOUR NADY
WIRELESS, page 18) for an optional
SINGLE RACK MOUNTING KIT (6a) and proceed as (6a) follows:
1. Attach the rack ears to the 2 holes on each side of the receiver with the supplied screws and mount the unit in the 19” audio equipment rack.
2.If you wish to also front mount the antennas, order the additional
c.Rack Mounting 2 Receivers Side by Side
If you want to rack mount 2 receivers
1.Remove the covers of both receivers by removing the 4 screws on the bottom plate
as shown. |
|
2. Join the 2 receivers together with the |
|
supplied bolts and nuts, while also joining |
|
the back of the receivers with the supplied |
|
double side tape as shown | (6c) |
|
3. Attach the rack ears to the 2 holes on the outer sides of the receivers with the supplied screws and mount the units in the 19” audio equipment rack.
4.If you wish to also front mount the antennas, order the additional
the
(6b)
(6d)
(6e)
6