Nady Systems UHF-16 owner manual UB-16Bodypack Transmitter, Selecting Input for Operation

OPERATING INSTRUCTIONS

UB-16 Bodypack Transmitter

1. Powering the Transmitter

Slide open the BATTERY COMPARTMENT (21) and insert 2 fresh AA ALKALINE BATTERIES (22), observing the correct polarity. Two fresh

alkaline batteries can last up to 12

hours in use, but in order to ensure(22)(21) optimum performance, it is

recommended that the battery be replaced after 8-10 hours of use.

2.Selecting Input for Operation

The UB-16 is equipped with an INPUT SELECTOR SWITCH (23) in the battery compartment for selecting the type of audio input you will be supplying to the transmitter. Select from the choice of three positions: GT (for guitar, bass, etc.) / HM (for headworn mic)/ LT (for lavalier mic).

(34)

Inside Battery Compartment (23)

3.Connecting the Audio Source

The UB-16 is provided with a 3.5 mm LOCKING JACK (27) for connecting the audio input selected. Connect either the INSTRUMENT (31) cord or the HEADWORN MIC (32) or LAVALIER MIC (33) cord as desired, according to the input selected.

To secure the connection, turn the slip ring on the plug clockwise to thread it on the jack. To unplug, reverse the process. Slip the transmitter into a pocket or CLIP (34) it on to your clothes or instrument strap (if using the UB-16 as an instrument transmitter).

(Note: Use only the input audio source as per the input selected with the AUDIO INPUT SELECTOR SWITCH or the audio will not be optimal– a muddy or distorted sound may result.)

(24)	(25)	(26)
Top View	(30)

(29) (28) (27)

4. Turning on the Transmitter

Turn on the UB-16 by sliding the OFF/STANDBY/ON SWITCH (28) to the STANDBY position (transmitter on, audio muted) or the ON position (transmitter and audio both on). The BATTERY INDICATOR LED

(30)will give a single quick flash, indicating usable battery strength. In the case of dead or low batteries, the LED either will not go on at all or will stay on continuously, indicating that the batteries should be

replaced with fresh ones. If the Tone Squelch™ is activated on both transmitter and receiver, the LOW TX BATTERY ICON (11c) on the receiver’s LCD DISPLAY (11) will switch from the battery OK to the LOW battery mode. See CHANNEL DISPLAY AND UP/DOWN BUTTON OPERATION, page 15 and UHF-16 OPERATING INSTRUCTIONS, page 8.

Inside the cover, the channel number on the CHANNEL LED DISPLAY (24) will extinguish in 10 seconds. The activity indicator “ ’’ or “ ’’ LED will remain on in the DISPLAY. See CHANNEL DISPLAY AND UP/DOWN BUTTON OPERATION, page 15.

12