Glossary
Ambush Code - In the event that you are forced by an intruder to disarm your system, this special code can be used to disarm the system, and simultaneously send a silent alarm to Central Station. If your system has the Ambush feature enabled, the code assigned as the User 4 code will function as your Ambush Code.
Arming / Disarming - Turning the system on or off by entering your user
code at the keypad, followed by.
Auto Interior Bypass - A feature which allows the system to recognize when you have not left the premises and automati- cally bypass any interior zones, deacti- vating devices such as motion sensors, allowing free movement throughout the premises.
Battery - A backup source of power to provide protection for a limited time in the event of a power failure.
Bypass - the manual or automatic re- moval of one or more protection zones from the system. Pressand then
14the zone number to bypass a zone.
Central Station - Monitors alarm, emergency and trouble reports from the alarm system and notifies proper authori- ties.
Chime - a keypad beep which indicates that a door has been opened while the system is disarmed.
Easy Exit - Allows an occupant to leave the premises without disarming the sys- tem. Pressing and then
while the system is armed will permit exit by removing the protection on the Exit/ Entry door for 3 minutes.
Exit/Entry Delay - The amount of time you are allowed to enter and leave the premises when the system is armed.
Exit/Entry Zone - A zone which will allow you to enter and leave the premises when the system is armed.
Instant Protection - Arming without En- try Delay while remaining on the premises. (Press while armed)
Keypad Sounder - A local warning de- vice at the keypad to alert that Entry delay has started,
System Trouble - A problem has been detected in the system which may pre- vent it from working properly.
TROUBLE will be lit to indicate a sys-
tem trouble.
User Code - A four digit code which is used to arm and disarm the system from the keypad.
User 1 Code - A four digit code which can be used to program,
Zone - An area which is protected by a security device. Your front door may be designated as Zone 1, while the living room motion detector may be Zone 2. Refer to the Zone Label on your keypad for the Zone Identification of your sys- tem.
Oi230a | Tuesday, September 16, 1997 08:26 |
page 14 |
|
