Napco Security Technologies GEM-P400 Table of Contents, System Information, Bell / Battery Test

Introduction

Table of Contents
Keypad Controls and Indicators	5
Arming your System (When Leaving)	6
Protecting Yourself While Home	7
Emergency Keys	8
Disarming the System	9
Silencing an Alarm	9
Special Functions	10
System Troubles	11
Programming User Codes	13
Glossary	14

System Information

Central Station Phone Number: ____________________

Central Station Account Number: ____________________

For Service Call: ____________________

Entry Delay: ____________________

Exit Delay: ____________________

Alarm Time-out: ____________________

4

Important - Test Your System Weekly !

1 Bell / Battery Test

Test your bell or siren by pressing￿followed by ￿.

This will cause the bell or siren to sound for 2 seconds and also initiate a test of the battery .

2 Zone Test

Walk throughout the premises opening each protected door or window, and activating each motion sensor. Check the keypad to see that each respective zone number displays in the window.

3 Central Station Communication Test

(This test should only be performed on weekends or at a time designated by your alarm company)

1 .Notify Central Station of the impending test.

2.Secure all zones to light Status Light on your keypad.

3.Enter your User Code followed by￿to Arm the system.

4.Violate your alarm by opening a window / door etc.

5.The siren or bell should sound and the system will send the alarm signals to the Central Station

6 .Enter your User Code followed by ￿￿to silence the alarm.

7.Call Central Station to insure that the alarm signals were received properly.

Oi230a	Tuesday, September 16, 1997 08:26
page 4