Napco Security Technologies GEM-P400 manual System Troubles

￿￿System Troubles

The GEM-P400 is constantly monitoring its own components, as well as all critical services, such as AC power and the telephone line, to insure that it is always ready to provide the protection for which it was designed. When a system trouble does occur, it will

caution you by lighting thelight and beeping the keypad buzzer.

If you cannot immediately clear the system trouble, the system can still be used. Simply press ￿followed by ￿to view the trouble as described below, and then arm the system.

To determine the nature of the trouble, press ￿followed by ￿, count the number of keypad beeps and observe the number of the illuminated zone. Refer to the following table to determine the cause of the trouble. If there is more than one trouble to view,

pressing ￿will scroll to the next trouble, and then exit the TROUBLE				mode if there are no more troubles to view.
Keypad Beeps or	Zone light	System Trouble		Action
Flashes	ON	Condition
1 Beep	1	AC Power Failure	This trouble will occur if AC power is not present. Make sure system transformer is
			plugged into AC receptacle and check the circuit breaker, otherwise call installing
			company for service.
1 Beep	2	Low Battery	If there has been a recent power failure, the battery may be partially depleted and
			must be recharged by the control panel. If the trouble does not go away in 24 hours,
			call installing company for service.
1 Beep	3	Communication	The system was not able to report to central station. If this is due to a temporary inter-
		Failure	ruption in the telephone service, the trouble can be cleared when the service is re-
			stored by pressing ￿followed by￿again to view the trouble, and and then
			pressing ￿to exit. Otherwise, call installing company for service.
1 Beep	4	Telephone Line Cut	The telephone line has failed. If telephone service has been temporarily interrupted,
			the trouble will clear it is when restored. Otherwise, call installing company for service.
2 Beeps	1	Bell/Siren Trouble	There is a problem with the Bell or Siren. Call installing company for service.

11

Oi230a	Tuesday, September 16, 1997 08:26
page 11