19
FINISHING
DOOR REMOVAL & INSTALLATION |
| L36 LOUVRE INSTALLATION |
The upper louvres must be removed to allow the door to be opened or closed. To access the lower door latch, open the valve control door. Release the top and bottom door latches, located at the right side of the door.
Note: The protective wrap is best removed when the assembly is at room temperature but this can be improved if the assembly is warmed, using a hair dryer or similar source.
FIGURE 34
FIGURE 35 a-c
B
C
A CLIPS
FLANGE
A
HOOD
C E N T R E
SLOT
B
C
HINGE
CLIP
SLOT
TA B
SLOT
Attach the hood by pressing the top flange into the clips along the top of the louvre opening. Secure using a screw through the centre slot.
UPPER LOUVRES
Insert the louvre tabs into the slots located at the top left and right corners of the unit.
LOWER LOUVRES
Insert the hinge clips into the slots located at the bottom left and right corners of the unit.
To remove the louvres, pull the back tabs of the clips forward, while pushing the louvre assem- bly back. Lift the clip.
