18
6.1.3Remove spring clip. Hold socket and pull out old bulb.
6.1.4Hold socket and push in new bulb (DO NOT exceed wattage). Replace spring clip.
6.1.5Repeat steps 3 and 4 for the second bulb.
6.1.6Insert bottom edge of removed cylinder half into bottom drum track.
Gently squeeze drum cylinder until its top edge fit into top drum rack.
Reattach the screw that was previously removed.
6.1.7Secure the backplate to the main appliance by reattaching the 7 screws removed.
FIGURE 6.1.2
FIGURE 6.1.6
6.2ember bed bulb replacement
6.2.1Remove the 7 screws from the bottom half of the back of appliance as illustrated. Remove back plate.
6.2.2Locate the ember bed bulbs which are underneath the flame generation cylinder drum.
6.2.3Remove spring clip. Hold socket and pull out old bulb.
BACK PLATE Mantel
Back View of Insert
2 Screws | 2 Screws |
On The | On The |
Side | Side |
3 Screws On The Back
FIGURE 6.2.1
LOCATE THE EMBER BED BULBS |
Flame Generation |
Cylinder Drum |
Bulbs with Spring Clips |
FIGURE 6.2.2
6.2.4Hold socket and push in new bulb (DO NOT exceed wattage or handle with bare hands).
6.2.5Repeat steps 3 and 4 for the second bulb.
6.2.6Secure the back plate to the main appliance by reattaching the 7 screws that were previously removed.
EMBER BED BULB |
REPLACEMENT |
FIGURE 6.2.4
6.3cleaning
6.3.1The glass is cleaned in the factory during assembly. During shipment, installation, handling, etc. the glass surface may collect dust particles. These can be removed by buffing lightly with a clean dry cloth.
6.3.2To remove fingerprints or other marks, the glass can be cleaned with a damp cloth using a good quality household glass cleaner. The glass should be completely dried with a lint free cloth or paper towel.
6.3.3In the event of glass breakage, vacuum all remaining glass pieces with a shop vac. DO NOT VACUUM
WHILE PIECES ARE HOT. Replace glass only with replacement part specifically for this appliance.
Never substitute material. Only fully tempered safety glass may be used on this appliance.
