3.3.1Remove cover plate located beside the power cord to reveal the 7/8” wire hole. Discard cover plate, screws and insert a box connector into the hole.
3.3.2Remove the lower back panel from the appliance to expose wiring.
3.3.3Remove the power cord
FIGURE 3.3.1
Remove 2 screws on cover plate.
FIGURE 3.3.3
Power Cord
Cut
9
FIGURE 3.3.2
Hot Wire
Common Wire
Ground Wire
FIGURE 3.3.4
Box
Connector
Final Connection
3.3.4Feed the supply
wires through the box connector and the grommet.
3.3.5Using wire connectors connect the common (white) wires together, then the hot (black) wires, and then the ground (green) wires.
3.3.6Ensure the newly connected wires are kept away from the rotating parts and the circuit board, and
NOTE: This appliance must be serviced from the back, leave enough wire so that the appliance can be removed from the enclosure without disconnecting the power supply wires.
