Napoleon Fireplaces EF30G manual 5.1remote control

16

5.1remote control

5.1.1Plug in your electric appliance.

	REMOTE CONTROL FOR ELECTRIC
5.1.2 Make sure the appliance's main Power ON/OFF button is at the ON position!	FIREPLACE
The remote control will NOT work if the main Power button is at the OFF	Infrared Ray Exit
position.	ON/OFF		Indicator
5.1.3 When operating the remote control, it must be directed towards the front
			Light
of the appliance.	-	+

5.1.4The button at the top left corner of the remote is the main ON/OFF power button. Pressing this button activates the power to the appliance.

5.1.5 To adjust the ember bed brightness, press the “+” or “-” buttons. To
increase the ember bed brightness, press the “+” button, to decrease	-
the ember bed brightness, press the "-" button. There are seven levels		+
of brightness.

5.1.6To activate the appliance, press the button. Press and release the button to cycle through LO, MED, HI and OFF. Each time the button

is pushed, the Appliance LED will change to its corresponding colour:

Green for LO, Orange for MED, Red for HI, and blank for OFF. The
appliance has a built-in thermostat so it will shut off automatically once the
	FIGURE 5.1
pre-set temperature is reached. It will also turn on automatically if the room
temperature drops below the pre-set temperature.

5.1.6To adjust the height of the flame, press the “+” or “-” buttons. To increase the height of the flame, press the “+” button, to decrease the height of the flame, press the "-" button. There are seven levels of flame effects.

5.1.7To turn off the appliance, press the ON/OFF button once.

NOTE: This remote control must remain within 8 meters or 26 feet of the appliance to be effective. Make sure your batteries are fully charged and installed correctly in your remote control.

W415-0760 / 12.19.08