Harman-Kardon DPR 1005 owner manual Main Remote Control Functions

MAIN REMOTE CONTROL FUNCTIONS

then select another channel to configure. When all adjustments have been completed, press the Set Button q twice to exit the settings and return to normal operation. (See page 24 for more information on speaker setup.)

Memory Button: Press this button to enter a radio station to the DPR 1005’s preset memory. First, tune the desired station, and then press this button. Within five seconds of when you see the station’s frequency flash in the Upper Display Line ^ and in the on-screen display, press the numeric keys

for the preset number between 01 and 30 that you wish to assign to the station. (See page 35 for more information.)

Stereo Mode Select Button: Press this button to select a stereo listening mode. When the button is pressed so that SURROUND OFF appears in the Lower Display Line &, the AVR will operate in a bypass mode with true, fully analog, two-channel left/right stereo mode with no surround processing or bass management, as opposed to other modes where digital processing is used. When the button is pressed so that SURROUND OFF appears in the Lower Display Line &, and the DSP and SURROUND OFF Surround Mode Indicators * are lit, you will enjoy a two-channel presentation of the sound along with the benefits of bass management. Depending on whether your system is configured for 5.1 or 6.1/7.1 channels, the next press of the button will cause either 5 CH STEREO or 7 CH STEREO to appear, and the stereo signal will be routed to all five (or seven) speakers. (See page 32 for more informa- tion on stereo playback modes.)

DTS Neo:6 Mode Select Button: Press this button as needed to select one of the DTS Neo:6 modes. (See page 32 for the available DTS Neo:6 options.)

DTS Digital Mode Select Button: When a DTS-encoded digital source is playing, each press of this button will scroll through the available DTS modes. The specific choice of modes will vary according to the type of encoding on the disc and your system’s speaker configuration. When a DTS source is not in use, this button has no function. (See page 32 for the available DTS digital options.)

Dolby Mode Select Button: This button is used to select from the available Dolby Surround modes. Each press of this button will select one of the Dolby Pro Logic II or Dolby Pro Logic IIx modes. When a Dolby Digital-encoded source is in use, the Dolby Digital mode may also be selected. (See page 32 for the available Dolby surround mode options.)

8-Channel Input Select: Press this button to select the device connected to the 8-Channel Direct Inputs 40 . (See page 30 for more information.)

SPL Select Button: This button activates the EzSet function to quickly and accurately calibrate the DPR 1005’s output levels. When the button is pressed you will then need to select between automatic EzSet operation or using the remote as a manual SPL meter by pressing the ⁄/¤ Navigation Button o until your choice appears in the remote’s LCD display. Press the Set Button q to enter the setting, and then follow the instructions as displayed in the LCD display. (For complete information, see page 27.)

EzSet Microphone Sensor: The microphone sensor that is used by the EzSet system is behind the three slots at the top of the remote control. When using EzSet to calibrate the DPR 1005, be certain that the slots are not covered. (See page 27 for more information on using EzSet.)

Lens: The infrared emitters behind the plastic lens at the top of the remote communicate the remote codes to the DPR 1005. Be certain that the lens is not covered when using the remote, and point the lens toward the DPR for best results. In learning mode, the remote receives IR codes to be learned through a sensor behind the lens.

NOTE: DO NOT remove the rubber plug that is supplied to cover the jack on the upper right side of the remote. The jack is not active and is reserved for future use.

14 MAIN REMOTE CONTROL FUNCTIONS