Harman-Kardon DPR 1005 Front-Panelcontrols, Standby/On Indicator, Input Source Selector

FRONT-PANEL CONTROLS

( * & ^ % $ #

1 2	3 4 5 6 7 8 9	)	! @
A	B C D E F G H J I K

NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at www.harmankardon.com.

The following controls and indicators are available on the DPR 1005’s front panel:

1 Standby/On Indicator	8 Input Source Selector	% Speaker/Channel Input Indicators
2 Standby/On Button	9 Tuning Mode Selector	^ Upper Display Line
3 Surround Mode Group Selector	) Set Button	& Lower Display Line
4 Surround Mode Selector	! ¤/⁄ Buttons	* Surround Mode Indicators
5 Tuning Selector	@ Front-Panel Control Door	( Remote Sensor Window
6 Tuner Band Selector	# Volume Control
7 Preset Station Selector	$ Input Indicators

The following controls and jacks are located behind the front-panel door. To open the door, press the center of the door and gently swing it down towards you.

A Main Power Switch	E Digital Input Selector	I Input/Output Indicator
B Tone Mode Button	F Delay Adjust Selector	J Coaxial 3 Digital Input
C Speaker Selector Button	G Headphone Jack	K Video 5 Audio/Video Jacks
D Channel Adjust Selector	H Optical 3 Digital Input

1Standby/On Indicator: This indicator is amber

when the DPR is in the Standby mode to signal that the unit is connected to an AC power source and is ready to be put into operation. When the unit is in use, the indicator turns blue.

2Standby/On Button: When the Main Power Switch A is “ON,” press this button to turn on the DPR 1005; press it again to turn the unit off.

3Surround Mode Group Selector: Press this but- ton to select the top-level group of surround modes. Each press of the button will select one of the sur- round mode categories. Once the button is pressed so that the name of the desired surround mode category appears in the on-screen display and in the Lower Display Line &, press the Surround Mode Selector 4 to cycle through the individual modes available. For example, press this button to select Dolby

modes, and then press the Surround Mode Selector

4to choose from the various mode options.

4Surround Mode Selector: Press this button to select from among the available surround mode options for the surround mode category selected. The specific modes will vary based on the number of speakers available, the surround mode category and whether the input source is digital or analog. For exam- ple, press the Surround Mode Group Selector 3

FRONT-PANEL CONTROLS 5