To adjust the on-screen appearance of the semi-OSD
system, press the OSD Button to bring the MASTER MENU to the screen. Press the ¤ Navigation Button o, until the on-screen ➔ cursor is next to the ADVANCED line. Press the Set Button q to enter the ADVANCED SELECT menu.
When the ADVANCED SELECT menu appears, press the ⁄/¤ Navigation Button o so that the on-screen➔ cursor is pointing to the SEMI OSD/TIME OUT line. Select one of these options:
•To keep the semi-OSD system activated, but to adjust the length of time the displays remain on the screen, press the ‹/› Navigation Button o until the desired time-out is shown. The default setting is 5 seconds.
•To turn the semi-OSD system off so that it does not appear at any time, press the ‹/› Navigation Button o so that OFF is shown on the right side of the line.
If you wish to make other adjustments, press the
⁄/¤ Navigation Button o until the on-screen ➔ cursor is next to the desired setting or the BACK TO MASTER MENU line and press the Set Button q. If you have no other adjustments to
make, press the OSD Button to exit the menu system.
Full-OSD Time-Out Adjustment
The FULL OSD menu system is used to simplify the setup and adjustment of the DPR 1005 by using a series of on-screen menus. The factory default setting for these menus leaves them on the screen for 20 seconds after a period of inactivity before they disap- pear from the screen (Time-Out). Time-Out is a safety measure to prevent image retention of the menu text in your monitor or projector, which might happen if it were left on indefinitely. However, some viewers may prefer a slightly longer or shorter period before the on-screen display disappears.
To change the full-OSD Time-Out, you will need to make an adjustment in the ADVANCED SELECT menu (Figure 16). To start the adjust-
ment, press the OSD Button to bring the MASTER MENU to the screen. Press the ¤
Navigation Button o, until the on-screen ➔ cursor is next to the ADVANCED line. Press the Set Button q to enter the ADVANCED SELECT menu (Figure 16).
At the ADVANCED SELECT menu (Fig. 16) make certain that the on-screen ➔ cursor is next to the FULL OSD TIME OUT line by pressing the ⁄/¤ Navigation Button o as needed. Next, press the ‹/› Navigation Button o until the desired time is displayed in seconds. Unlike most of the other options in this menu, this is a permanent setting change, and the Time-Out entry will remain in effect until it is changed, even if the unit is turned off.
If you wish to make other adjustments, press the ⁄/¤ Navigation Button o until the on-screen
➔cursor is next to the desired setting or the BACK TO MASTER MENU line and press the Set Button q. If you have no other adjust-
ments to make, press the OSD Button | to exit |
the menu system. | |
