4
IMPORTANT INSTRUCTIONS |
| LOCATING YOUR ELECTRIC FIRE- |
1.READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. THIS APPLIANCE IS HOT WHEN USED.
2.To avoid burns, DO NOT let bare skin touch hot surfaces. The trim around the heat outlet becomes hot during fi replace operation. Keep combustible material; such as furniture, pillows, bedding, paper, clothes and draperies at least 3 feet from the front of the unit.
3.CAUTION: Extreme caution is necessary when any fireplace is used by or near children or invalids, also whenever the heater is left operating and unattended.
4.Do not operate if the power cord or fi replace is damaged, or if the unit is dropped or damaged in any manner.
5.Under no circumstances should this fi replace be modifi ed. Use it only as described in the manual. Any repairs to the fi replace should be carried out by a qualifi ed service person.
6.Do not use outdoors.
7.Do not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause an electrical short or fi re. This could also damage the fi replace.
8.To prevent a possible fi re, DO NOT block air intakes or exhaust in any manner. DO NOT use on soft surfaces where openings may become blocked.
9.This heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline, paint or fl ammable liquids are used or stored. This fi replace SHOULD NOT be used as a drying rack.
10.This fireplace is NOT intended for wood or other flammable material to be burned inside of it.
11.Make sure the fi replace is unplugged before any cleaning or maintenance is performed on the heater.
12.Avoid the use of extension cords. The extension cord may overheat and cause a fi re.
13.Do not strike the glass on the fi replace.
14.Always unplug heater when not in use.
15.This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
16.Do not run cord under carpeting. Do not cover cord with throw rugs, runners or similar coverings. Arrange cord away from traffi c area and where it will not be tripped over.
17.To disconnect heater, turn controls to off, then remove the plug from the outlet.
18.Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fi re, electric shock or injury to persons.
19.SAVE THESE INSTRUCTIONS.
Your new fi replace may be installed into an existing masonry or zero clearance fi replace. It may also be installed using a prefabricated cabinet available from your dealer or may be built into a wall. For the best effect, install the fi replace out of direct sunlight.
