14
GLOWING EMBERS
Tear the embers into small pieces and place on the ported area of the burner. Care should be taken to shred the embers into thin, small irregular pieces as only the ex- posed edges of the fibre hairs will glow. The ember mate- rial will only glow when exposed to direct flame; however, care should be taken to not block the burner ports. Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when
Dashed lines are suitable mantle sizes and clear- ances when a
FIGURE 25
HOOD
exposed to direct flame.
CHARCOAL EMBERS
Randomly place the embers around the bottom brick pan- els in a realistic manner but not in contact with the flames. Keep ember dust away from burner ports to avoid plugging them.
Fine dust found in bottom of bag not to be used. PHAZERTM logs, and embers glow when exposed to direct flame. Use only certified PHAZERTM logs, glowing embers and char- coal embers available from your Napoleon / Wolf Steel Ltd. dealer.
HOOD
CURTAIN
MESH
FIGURE 26
GLOWING EMBERS
The curtain mesh must be kept fully closed during opera- tion to help prevent accidental burns from occurring.
22 |
CURTAIN SUPPORT
PLATE
HOOD
FIGURE 27
The heater must not be used when the hood is re- moved. Hook the hood over the lip of the curtain support plate.
Ensure that glowing embers sufficiently cover the carry over ports, highlighted below, to achieve maximum glow.
CARRY OVER PORTS
FIGURE 23
MANTLE INSTALLATION
Combustible mantle clearance can vary according to the mantle depth. Use the graph to help evaluate the clear- ance needed. The
FIGURE 24
UPPER LOUVRE BRACKETS & HOOD
FIGURE 28
Attach the hood with louvre brackets by pressing the top flange of the bracket into the clips along the top of the louvre opening with louvre securing tabs facing out.
NOTE: The protective wrap is best removed when the assembly is at room temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat source.
