10
LOG PLACEMENT
PHAZERTM logs, exclusive to Napoleon Fireplaces, provide a unique and realistic glowing effect that is different in every installation. These logs are fuel specific. Do not
interchange. Refer to the replacement parts list.
Failure to follow these log placement instructions may cause sooting.
5. Position the holes on the bottom of #5 on the pin on the left end of log #1 and the pin on the left end of
log #2.
1.Place the rear log #1 onto the locating studs on the rear log support.
3.Position the holes on the bottom of log #3 onto the pins shown, with the charred face forward.
2.Position the holes on the bottom of log #2 onto the pins shown.
6.Place the end of log #6 on the right end of log #1. The fork in the log should straddle the knot on top of the log
#2. .
Log colours
may vary. During the initial use of the fire- place, the colours will become more uniform as colour pigments burn in during the heat activated curing process.
Positioning the logs improperly will cause flame im- pingement and carboning.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct flame. Use only certified PHAZERTM logs available from your Napoleon dealer.
WARNING
Failure to position the parts in accordance with these diagrams or failure to use only parts specifi- cally approved with this heater may result in prop- erty damage or personal injury.
LOGO PLACEMENT
4.Position the holes on the bottom of log #4 onto the pins shown, with the
charred face inward.
LOGO
½" 
LOGO
½" 
Remove the backing of the logo supplied. Centre the logo on the front of the appliance, ½” in from the left side, as shown.
