2
TABLE OF CONTENTS
2Warnings
3Warranty
Minimum Fireplace Size Andiron and Grate Assembly Gas Piping
Combustion and Ventilation Determining Confined or Unconfined Space
7Installing In A Vented Application Damper Stop Installation
Operating Instructions
Lighting Instructions
ODS Pilot Cleaning
Match Lighting Instructions
10Log Placement Logo Placement
11Finishing Rating Plate
12Replacement Parts Accessories
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE
WARNINGS
•Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies.
•Children and adults should be alerted to the hazard of high surface temperatures and should stay away to avoid burns or clothing ignition.
•Young children should be carefully supervised when they are in the same room with the appliance.
•Do not place clothing or other flammable material on or near the appliance.
•Any safety screen or guard removed for servicing an appliance must be replaced prior to operating the heater.
•Installation and repair should be done by a quali- fied service person. The appliance should be in- spected before use and at least annually by a pro- fessional service person. More frequent cleaning may be required due to excessive lint from carpet- ing, bedding material, etc. It is imperative that con- trol compartments, burners and circulating air pas- sageways of the appliance be kept clean.
•Any change to this heater or it’s controls can be dangerous.
•The fireplace and gas logs function as a system. If the fireplace is not drafting properly and spilling into the room (check with a match or a smoke stick), reposition the damper clamp until a positive draft is obtained by opening the damper. If negative pressure in home prevents having a positive draft, consult an air quality specialist.
•The gas log heater must be secured to the fireplace floor to ensure that the position is not changed while adjusting the controls.
•Sooting and an improper burn may result from shifting of the gas logs by moving the unit. A gas leak could be caused by moving the grate.
•If you are installing the unit into a sunken fireplace, you must raise the fireplace floor to allow access to the gas log controls. Raising the floor ensures adequate air flow and guards against sooting. The fireplace floor must be raised using noncombustible materials.
•This appliance is for installation only in a
•This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.
•A fireplace screen must be in place when the appliance is operating and, unless other provisions for combustion air are provided, the screen shall have an opening for introduction of combustion air.
•Any glass doors shall be completely opened when the appliance is in operation.
•State or local codes may only allow operation of this appliance in a vented configuration. Check your state or local codes.
•Do not use a blower insert, heat exchanger insert or any other accessory not approved for use with this appliance.