Napoleon Fireplaces GVF40N Gvfl Installation, Heat Shield Stand-Off Removal, Logo Placement

LOWERLOUVREBRACKETS&HINGESCREEN

15

A B

FIGURES 29

Using 6 screws, attach the lower louvre brackets and hinge screen as illustrated. Be sure to install the louvre brack- ets over the hinge screen.

GVFL INSTALLATION

B

C

HINGE

CLIP

S L O T

TA B

S L O T

UPPER LOUVRES

Insert the louvre tabs into the slots located at the top left and right corners of the unit.

LOWER LOUVRES

Insert the hinge clips into the slots located at the bottom left and right corners of the unit.

HOOD

BRACKET

SLOT

30LOUVRE

31LOWER LOUVRES (VALVE CONTROL DOOR)

TO INSTALL THE UP- PER LOUVRES: Insert the upper louvres into the slots on both brack- ets. Press the top flange of the hood into the four clips located along the top of the unit as shown.

TO INSTALL THE LOWER LOUVRE AS- SEMBLY: Attach each hinge to the firebox with 2 screws.

To remove the louvres, pull the back tabs of the clips forward, while pushing the louvre assem- bly back. Lift the clip.

HEAT SHIELD STAND-OFF

REMOVAL

HEAT SHIELD

L36 LOUVRE INSTALLATION

FIGURE 32 a-c A

B

C

FIGURE 33	STAND-
	OFFS

END HEAT SHIELD SHOWN

When using a non-combustible finishing material, the stand-offs may be removed, by removing the set screw in the centre and sliding the stand-offs out of the mounting clips.

LOGO PLACEMENT

Remove the backing of the logo supplied and place on the screen cover, as indicated.

A CLIPS

FLANGE

C E N T R E

S L O T

HOOD

Attach the hood by pressing the top flange into the clips along the top of the louvre opening. Secure using a screw through the centre slot.

FIGURE 34

W415-0319 / D / 08.03.05