Step 3
Attach emitter screen (5) to burner column (3) using three M4 x 8 bolts (9)
Note: The ignition hole on emitter screen must line to the control knob.
Step 4
Attach reflector dome (6) to emitter screen (5) using six 6mm washers (12) and three M6 nuts (11).
Then attach dome cap (7) and decorative dome cap nut (8) to reflector dome (6).
| ASSEMBLY |
Step 2 |
|
| Ignition |
| Hole |
ODS Hole | 9 |
| |
| 3 |
Hardware Used
9 M4 x 8 bolt | X 3 |
Step 4
8
7
11
12
12
5
Hardware Used
11 | M6 nut | X 3 |
3 | 6mm Washer | X 6 |
12 |
8
