14
www.napoleongrills.com
WARNING! When reinstalling the burner aer cleaning it is very
important that the valve/orice enters the burner tube before lighng your
gas grill. If the valve is not inside the burner tube a re or explosion could
occur.
Burner: The burner is made from heavy wall 304 stainless steel, but extreme heat and a corrosive environ-
ment can cause surface corrosion to occur. This can be removed with a brass wire brush.
CAUTION! Beware of Spiders.
Spiders and insects are aracted to the smell of propane and natural gas. The burner is equipped with an
insect screen on the air shuer, which reduces the likelihood of insects building nests inside the burner but
does not enrely eliminate the problem. A nest or web can cause the burner to burn with a so yellow or
orange ame or cause a re (ashback) at the air shuer underneath the control panel. To clean the inside of
the burner, it must be removed from the gas grill: Remove the screw (s) that aaches the burner to the back
wall. Slide the burner back and up wards to remove. Cleaning: Use a exible venturi tube brush to clean the
inside of the burner. Shake any loose debris from the burner through the gas inlet. Check the burner ports
and valve orices for blockages. Burner ports can close over me due to cooking debris and corrosion, use
an opened paperclip or the supplied port maintenance bit to clean them. Drill out blocked ports using this
drill bit in a small cordless drill. The ports are easier to clean if the burner is removed from the grill, but it can
also be done with the burner installed. Do not ex the drill bit when drilling the ports, as this will cause the
drill bit to break. This drill is for burner ports only, not for the brass orices (jets) which regulate the ow into
the burner. Take care not to enlarge the holes. Ensure the insect screen is clean, ght, and free of any lint or
other debris.
Reinstallaon: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing. Replace sear plate mount and / or ghten screws to complete reinstallaon.