Index
PCMCIA Serial for Windows Me/9x I-4 ni.com
successful uninstallation (figure), B-4
uninstalling, B-3
setting transceiver control mode, 4-3
setting with DeviceloControl, 4-4
setup screen for NI-Serial software
(figure), 2-2
software installation, 2-1
getting started, 1-2
software specifications, D-2
specifications, D-1
environmental characteristics, D-2
physical characteristics, D-1
software specifications, D-2
standard DOS-based addresses (table), C-5
stop bits, 3-3
straight-through cabling in a DTE-to-DCE
interface (figure), A-6
successful uninstallation (figure), B-4
system integration, by National
Instruments, E-1
T
technical support resources, E-1
termination, A-5
multidrop network using terminating
resistors (figure), A-5
time-saving development tools, 1-4
transceiver control modes (table), 4-2
transceiver mode, 3-4
setting with DeviceloControl, 4-4
transceiver mode control bytes (figure), 4-3
troubleshooting, C-1
diagnostic messages, C-2
forcing Windows to detect your
hardware,C-3
freeing an interrupt request level, C-1
resolving resource conflicts with legacy
boards, C-3
selecting conflict-free resources, C-2
two-wire devices, 2-9
connecting, 2-9
typical full-duplex system (figure), A-4
typical half-duplex system (figure), A-4
U
uninstalling serial hardware, B-1
uninstalling serial software, B-3
using FIFO buffers, 3-4
using serial hardware, 4-1
using this manual, 1-1
V
verifying hardware installation, 2-4
verifying hardware resources, 2-6
viewing or changing communication port
settings, 3-1
W
Web support from National Instruments, E-1
Win32 Overviews and Win32 Reference, 4-1
Win32 Software Development Kit, 4-1
worldwide technical support, E-2