© National Instruments Corporation 13 cFP-2200/2210/2220
Installing the cFP-22xx on the Backplane
1. Make sure that no power is connected to the controller.
2. Make sure that the controller is right side up with the NI logo at the top,
and align the captive screws on the controller with the holes on the
backplane.
3. Seat the card edge at the back of the controller in the card-edge
connector on the backplane.
4. Press the controller firmly to seat it on the backplane.
Figure 19. Installing the Controller on the Backplane
5. Using a number 2 Phillips screwdriver with a shank of at least 64 mm
(2.5 in.) length, tighten the captive screws to 1.1 N · m (10 lb · in.) of
torque.