© National Instruments Corporation 15 cFP-2200/2210/2220
Installing Connector Blocks on the Backplane
In order to connect I/O modules to input signals or loads, you need to install
a cFP-CB-x connector block or other connectibility accessory for each I/O
module on the backplane. Use the connector socket to the right of each I/O
module socket.
Caution Do not insert or remove connector blocks or other connectivity accessories while
power is applied to them.
1. Wire signals or loads as described in the I/O module and connector
block operating instructions.
Caution Hazardous voltage wiring should be performed by qualified personnel and in
accordance with local electrical standards.
2. Align the captive screws on the connector block with the holes on the
backplane.
3. Press firmly to seat the connector block on the backplane.