Chapter2 Installation
©NationalInstruments Corporation 2-7 GPIB-SCSI-Afor Solaris
Figure 2-4 showswhere toinstall terminating resistors if the GPIB-SCSI-A
is located at the end of a system.
Figure2-4. Location of Terminating Resistors for GPIB-SCSI-A at End of SCSI Bus
Ify our GPIB-SCSI-A is not located at the end of the SCSI bus, remove
the terminating resistor pack from the rear panel of the GPIB-SCSI-A. Also
ensurethat all other devices in the middle of the bus (for example, the SCSI
disk drivein Figure 2-5) do not have terminating resistors installed. The
devicesat each end of the SCSI bus should have terminating resistors
installed.
1 ToGPIB Devices
2 TerminatingResistors
3 GPIB-SCSI-A
4 SCSITape Drive
5SCSIDiskDrive
6SCSIHost
POWERREADYTALKLISTENSENDRECEIVE
GPIB-SCSI-A
IEEE-488SCSICONTROLLER
1
2
3
4
5
6
GS.book Page 7 Tuesday, June 12, 2001 2:17PM