© National Instruments Corporation 2-1 NI 8352/8353 User Manual
2
Installation and BIOS Setup
This chapter describes how to install, configure, and use the NI 8352/8353.
Before connecting the NI 8352/8353 to a power source, read this chapter
and the Read Me First: Safety and Radio-Frequency Interference
document included with your NI 8352/8353.
Safety Information
Caution Before undertaking any troubleshooting, maintenance, or exploratory procedure,
carefully read the following caution notices.
This equipment contains voltage hazardous to human life and safety, and is
capable of inflicting personal injury.
•Chassis Grounding—The NI 8352/8353 requires a connection from
the premise wire safety ground to the NI 8352/8353 chassis ground.
The earth safety ground must be connected during use of this
equipment to minimize shock hazards. Refer to the Connecting Safety
Ground section for instructions on connecting safety ground.
•Live Circuits—Operating personnel and service personnel must
not remove protective covers when operating or servicing the
NI 8352/8353. Adjustments and service to internal components must
be undertaken by qualified service technicians. During service of
this product, the mains connector to the premise wiring must be
disconnected. Dangerous voltages may be present under certain
conditions; use extreme caution.
•Explosive Atmosphere—Do not operate the chassis in conditions
where flammable gases are present. Under such conditions, this
equipment is unsafe and may ignite the gases or gas fumes.
•Parts Replacement—Service this equipment only with parts that
are exact replacements, both electrically and mechanically. Contact
National Instruments for replacement part information. Installation of
parts with those that are not direct replacements may cause harm to
personnel operating the chassis. Furthermore, damage or fire may
occur if replacement parts are unsuitable.