
STEP 3:
Once the screws are fixed in the wall, insert the four screw heads through the large parts of the
⇒ |
Wiring Requirements
WARNING
Do not disconnect modules or wires unless the power supply has been switched off or the area is known to be
The devices are designed for operation with a Safety
WARNING
Substitution of components may impair suitability for Class I, Division 2, and Zone 2. These devices must be supplied by an SELV source as defined in Low Voltage Directive 73/23/EEC and 93/68/EEC.
WARNING
This unit is a
WARNING
Safety First!
Be sure to disconnect the power cord before installing and/or wiring your Switch.
Calculate the maximum possible current in each power wire and common wire. Observe all electrical codes dictating the maximum current allowable for each wire size.
If the current goes above the maximum ratings, the wiring could overheat, causing serious damage to your equipment.
— 5 —