National Instruments SCC-AO10 manual 5

E/M Series
DAQ Device		SCC-AO10 in Socket J18
					3
	AO 1				2		+
							VOUT2		+
	AO GND				1		–
				I
									VOutTotal
			SCC-AO10 in Socket J17
						3
	AO 0
						2	+	Load
							VOUT1			–
	AO GND						–
						1
				I

Figure 3. Connecting Two SCC-AO10 Modules in Series

The SC-2345/2350 routes the E/M Series DAQ device analog output channels AO 0 and AO 1 to the SCC-AO10 modules, and the resulting maximum output voltage range is ±20 V. Refer to Figure 3 and use the following formula to calculate the total output voltage from both SCC-AO10 modules:

VOutTotal = VOUT1 + VOUT2

where

VOutTotal is the total output voltage from both SCC-AO10 modules

VOUT1 is the voltage across terminals 1 and 3 of the SCC-AO10 module in socket J17

VOUT2 is the voltage across terminals 1 and 3 of the SCC-AO10 module in socket J18

For information about how to configure the SCC-AO10 module with NI-DAQmx, refer to the SCC Quick Start Guide.

© National Instruments Corporation 5 SCC-AO10 Isolated Analog Output Module User Guide