Chapter 1 Installing and Configuring the SCXI-1127/1128
© National Instruments Corporation 1-15 SCXI-1127/1128 User Manual
Refer to Figure 1-8 to set up this multichassis configuration.
Figure 1-8. 12-Slot to 12-Slot Multichassis Configuration Parts Locator Diagram
1. Install the HVAB-backplane adapters and jumper blocks in the 12-slot
chassis as described in steps 1 through 3 in Single 12-Slot Chassis
Configuration.
2. Connect the HV8-HV8 cable from the first chassis, normally the
connector behind slot 1, to the HVAB connector (behind slot 12) of the
next chassis.
3. Connect the SH9MD-9MD cable from the AUX OUT connector of the
first chassis to the AUX IN connector (behind slot 5) of the next
chassis.
4. Repeat steps 1 through 3 for each additional chassis.
1 8-Slot HVAB-Backplane Adapter
2 HV8-BAN4 Cable
3 8-Position HVAB Plug
4 2-Slot HVAB-Backplane Adapter
5 1-Slot HVAB-Backplane Adapter
6 NI 4060 for PCI
7 SH9MD-9MD Cable
8 12-Slot SCXI Chassis
9 HV8-HV8 Cable
10 12-Sl ot SCXI Chassis
11 SH9MD-9MD Cable
AB0+
AB0–
AB2+
AB2–
6
8
9
7
10
1 32
11
4 5