National Instruments VXI-MIO Series , UISOURCE Signal

Chapter 4 Signal Connections
 National Instruments Corporation 4-37 VXI-MIO Series User Manual
Figure 4-26. UPDATE* Input Signal Timing
Figure 4-27. UPDATE* Output Signal Timing
The DACs are updated within 100 ns of the leading edge. Separate the
UPDATE* pulses with enough time that new data can be written to the
DAC latches.
The VXI-MIO Series module UI counter normally generates the
UPDATE* signal unless you select some external source. The UI
counter is started by the WFTRIG signal and can be stopped by software
or the internal Buffer Counter.
D/A conversions generated by either an internal or external UPDATE*
signal do not occur when gated by the software command register gate.
UISOURCE Signal
Any PFI pin can externally input the UISOURCE signal, which is not
available as an output on the I/O connector. The UI counter uses the
UISOURCE signal as a clock to time the generation of the UPDATE*
signal. You must configure the PFI pin you select as the source for the
UISOURCE signal in the level-detection mode. You can configure the
Rising-edge
polarity
Falling-edge
polarity
tw
tw= 10 ns minimum
tw
tw= 300-350 ns