NEC 4200W Connecting Your PC Or Macintosh Computer, Connecting Your Document Camera, Connecting Your VCR Or Laser Disc Player, Connecting Your DVD Player

Connecting Your PC Or Macintosh Computer

Connecting your PC or Macintosh computer to your PlasmaSync 4200W will enable you to display your computer's screen image for an impressive presentation. The PlasmaSync 4200W supports the signals described on page 12.

To connect to a PC, Macintosh or computer equipped with an SVGA/VGA adapter or compatible graphics adapter, simply:

1.Turn off the power to your PlasmaSync 4200W and computer.

2.If your PC does not support SVGA/VGA you will need to install an SVGA/VGA graphics board. Consult your computer's owner's manual for your SVGA/VGA configu- ration. If you need to install a new board, see the manual that comes with your new graphics board for installation instructions.

3.Use the signal cable that's supplied to connect your PC or Macintosh computer to the PlasmaSync 4200W. For Macintosh, use the supplied monitor adapter to connect to your computer's video port.

4.Turn on the PlasmaSync 4200W and the computer.

5.If the PlasmaSync 4200W goes blank after a period of inactivity, it may be caused by a screen saver installed on the computer you've connected to the PlasmaSync 4200W.

When using a Macintosh with the PlasmaSync 4200W, set the DIP switch of the supplied monitor adapter according to your resolution. After setting, restart your Macintosh.

See the following pages for setting of the DIP switch.

Examples of DIP switch setting

13” fixed mode

ON

→

1 2 3 4 5 6 7 8

Connecting Your Document Camera

You can connect your PlasmaSync 4200W to a document camera. To do so, simply:

1.Turn off the power to your PlasmaSync 4200W and document camera.

2.Use a standard video cable to connect your document camera to the Video input on your PlasmaSync 4200W.

3.Turn on the PlasmaSync 4200W and the document cam- era.

Note: Refer to your document camera's owner's manual for more information about your camera's video output requirements.

Connecting Your VCR Or Laser Disc Player

Use common RCA cables (not provided) to connect your VCR or laser disc player to your PlasmaSync 4200W. To make these connections, simply:

1.Turn off the power to your PlasmaSync 4200W and VCR or laser disc player.

2.Connect one end of your RCA cable to the video out- put connector on the back of your VCR or laser disc player, connect the other end to the Video input on your PlasmaSync 4200W. Use standard RCA audio patch cords to connect the audio from your VCR or laser disc player to your PlasmaSync 4200W (if your VCR or laser disc player has this capability). Be careful to keep your right and left channel connections correct for stereo sound.

3.Turn on the PlasmaSync 4200W and the VCR or laser disc player.

Note: Refer to your VCR or laser disc player owner's manual for more information about your equipment's video output requirements.

Connecting Your DVD Player

You can connect your PlasmaSync 4200W to a DVD player. To do so, simply:

1.Turn off the power to your PlasmaSync 4200W and DVD player.

2.Use a standard video cable to connect your DVD player to theY, Cb, and Cr inputs on your PlasmaSync 4200W.

3.Turn on the PlasmaSync 4200W and the DVD player.

9