NEC 4200W Basic Operations, POWER, VOLUME, MUTE, DISPLAY, VISUAL CONTROL

Basic Operations

POWER

To turn the unit ON and OFF:

1.Plug the power cord into an active AC power outlet.

2.Press the POWER button (on the remote controller) to turn on.

The monitor’s POWER/STANDBY indicator will light up(green) when the unit is on.

3.Press the POWER button (on the remote controller or the unit) to turn off.

The monitor’s POWER/STANDBY indicator turns red and the standby mode is set.

VOLUME

To adjust the volume:

1.Press and hold the VOLUME ▲ button (on the remote controller or the unit) to increase to the desired level.

2.Press and hold the VOLUME ▼ button (on the remote controller or the unit) to decrease to the desired level.

MUTE

To cancel the sound:

Press the MUTE button on the remote controller to cancel

sound; press again to restore.

DISPLAY

To check the settings:

1.The screen changes each time the DISPLAY button is pressed.

2.If the button is not pressed for approximately three sec- onds, the menu turn off.

VISUAL CONTROL

TO adjust the picture's contrast:

1, Press and hold the CONTRAST ▲ button for higher contrast.

2, Press and hold the CONTRAST ▼ button for lower contrast.

TO adjust the picture's brightness:

1, Press and hold the BRIGHT ▲ button for a brighter picture.

2, Press and hold the BRIGHT ▼ button for a darker pic- ture.

TO adjust the picture's color:

1, Press and hold the COLOR ▲ button for more color saturation.

2, Press and hold the COLOR ▼ button for less color satu- ration.

TO adjust the picture's tint (NTSC only):

1, Press and hold the TINT ▲ button for a greener tint. 2, Press and hold the TINT ▼ button for a redder tint.

TO adjust the picture's sharpness:

1, Press and hold the SHARPNESS ▲ button for a sharper picture.

2, Press and hold the SHARPNESS ▼ button for a softer picture.

*If no key operation is made within five seconds, the OSM display will disappear.

13