Installation

Connecting the Projector

Connect to Computer/Notebook

Make sure that the power plug is fully inserted into both the projector AC inlet and the wall outlet.

To the wall outlet

MOLEX

3

4

5

6

2

SD CARD

molex

1

E62405SP R

7

Note:

When Viewing a DVI Digital Signal

•Use a DVI-to-HDMI cable compliant with DDWG (Digital Display Working Group) DVI (Digital Visual Interface) revision 1.0 standard. The cable should be within 197”/5 m long.

•Turn off the projector and the PC before connecting the DVI-to-HDMI cable.

•To project a DVI digital signal: Connect the cables, turn the projector on, then select the HDMI input. Finally, turn on your PC.

Failure to do so may not activate the digital output of the graphics card resulting in no picture being dis- played. Should this happen, restart your PC.

•Some graphics cards have both analog RGB (15-pin D-Sub) and DVI (or DFP) outputs. Use of the 15-pin D-Sub connector may result in no picture being displayed from the digital output of the graphics card.

•Do not disconnect the DVI-to-HDMI cable while the projector is running. If the signal cable

1

.............................................................................................Power cord (supplied)

2

......................................................................................................................SD Card

3

...............................................................................................................HDMI cable

4

........................................................................ Computer cable (VGA) (supplied)

5

...........................................................................................................Audio in cable

6

................................................................................................USB cable (supplied)

7

................................................................................................ USB memory device

English ... 12