NEC LCD1960NX manual Quick Start, Turn off the power to your computer

Quick Start

To attach the MultiSync¨ LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the connector of the display card in your system (Figure A.1). Tighten all screws. For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws.

For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure B.1). Tighten all screws.

NOTE: To obtain the MultiSync LCD1960NXTM Macintosh cable adapter, call NEC- Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.

3.Remove the cable cover. Connect the 15-pin mini D-SUB of the video signal cable and DVI signal cable (not included) to the appropriate connector on the back of the monitor (Figure C.1).

4.Connect one end of the power cord to the monitor and the other end to the power outlet. Place the Video Signal Cable and power cord under Cable cover (Figure C.1). Replace cable cover.

NOTE: Adjust position of cable that place under cable cover, to avoid damage for cable or monitor.

NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use section of this manual for proper selection of power cord.

5.The vacation switch on the left side of the monitor must be turned on (Figure D.1). Turn on the monitor with the front power button and the computer.

NOTE: The vacation switch is a true on/off switch. If this switch is on the OFF position, the monitor cannot be turned on using the front button. DO NOT switch on/off repeatedly.

6.Analog input only: No-Touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings. For further adjustments, use the following OSM¨ controls:

¥Auto Adjust Contrast

¥Auto Adjust

Refer to the Controls section of this User Õs Manual for a full description of these OSM controls.

NOTE: For download information on the Windows¨ 95/98/Me/2000/XP INF file for your MultiSync LCD1960NX monitor, refer to the References section of this UserÕs Manual.

NOTE: If you have any problems, please refer to the Troubleshooting section of this UserÕs Manual.

Figure A.1 Figure A.2 Figure B.1

DVI signal cable		Macintosh Cable	Note: Some Macintosh
			systems do not require
		Adapter (not include)
(not included)	3		a Macintosh Cable Adapter

LCD1960NX050603.p65 3 5/21/03, 1:06 PM