Dukane 403-570-01 Tooling Specifications, Machine Weight, Power Requirements, Tooling Size

Section 12 - Specifications

Tooling Specifications

Tooling Size

Refer to Table 5-I for maximum tooling sizes.

Machine Weight

The Dual Servo Spin Welder weighs approximately 400 lbs. (182 kg). It should be mounted on a table or bench capable of supporting 650 lbs. (295 kg) to accommodate the additional force imposed by the vertical movement of the motor and slide during the spin welding operation.

Use mechanical means such as a forklift or hoist to place the servo spin welder on its work bench. There are two 3/4 inch lifting eyes located at the top of the column (see Figure 3–7) for a lifting ring or strap.

Power Requirements

The Dual Servo Spin Welder requires a 240 VAC 1– phase outlet rated at 20 Amps. All welder models use the same power cord and plug. The AC power cord has a 240 VAC, single phase plug which is designed for a NEMA 6–20R configuration wall receptacle shown in Figure 12–1.

Operating

Environment

Operate the Dual Servo Spin Welder within these guidelines:

Temperature:	40°F to 95°F (+5°C to +35°C)
Altitude:	4570 m (15,000 ft)
Air Particulates:	Keep the welder dry.
	Minimize exposure to moisture, dust
	dirt, smoke and mold.
Humidity:	5% to 95% non–condensing @ +5°C to
	+30°C

24020 Volt AC Socket

(NEMA 6–20R)

Figure 12–1240V AC Single–Phase AC Receptacle

Dukane Manual Part No. 403-570-01 Page  91